Canbus can bus - EBB36 EBB42 Install with Klipper on Core-XY Voron 2.4

This video details the install or retrofit of a Voron 2.4 core-xy printer to canbus via the BigTreeTech EBB36 and the Waveshare RS485 Canbus Hat can bus for the Raspberry Pi 4. It covers installing Klipper onto the EBB36 card mounting cables umbilical and reconfiguration of the printer.cfg files. This should mostly apply to the EBB42 and some is applicable to the fly sht 36 fly sht 42 Huvud turbocan and canable can bus controllers. Special note: When making the video I failed to record terminating the EBB36. For reliable communications on the canbus please make sure you terminate the EBB36 with the jumper. A Raspberry PI 4 or CM 4 are highly recommended. People have reported communication issues with the Raspberry PI 3. Devices more powerful than a Raspberry PI 4 are probably fine as well. Resources used I receive commissions that directly contribute to content creation on this site: The EBB36 U2C: EBB36: U2C: CanHat: Green filament: The filament: or The military green ABS and black ASA filament: Maz0rs github page on how to configure canbus: BigTreeTech github instructions: Useful wiring guide: Voron Startup instructions and checks: Rear Umbilical mount the one used in the video: Rear Umbilical mount the version I modified for more clearance: Front EBB36 mount: I used this for the z-chain relocation: Instagram: My printer.cfg file: Carriage mount with x-endstop mount: Discord Can-Bus stop: Fluidscape by Kevin MacLeod is licensed under a Creative Commons Attribution 4.0 license. Source: Artist: ,